TRY STEAL THIS!
The Ghost is the original aftermarket CAN bus immobiliser. Protect your car from theft like nothing else on the market today.
The Ghost protects your car from key-cloning, hacking, and even key theft. The Ghost has no key-fobs or LED indications to give away its location. The Ghost uses the buttons in your vehicle such as those on the steering wheel, door panels or centre console, to allow you to make a unique, changeable, disarm sequence (like a PIN code) that must first be entered before you can drive your car. Just like your credit card but you can make your car disarm sequence even safer by making it up to 20 presses long!
In order to make extreme security also be hassle free, we have created a smart-phone application that connects to your car and allows you to get in and drive without having to enter the disarm sequence. This Ghost-II allows 2 phones to be connected. All you have to do is pair your phone with your Ghost-II, leave the Autowatch Ghost-II application running in the background with Bluetooth enabled and you can drive conveniently and securely. However, remember that if you phone is in range (5m to 10m) and the application is running the Ghost-II will be disarmed.
Vehicle Start Blocking
The Ghost System will in most cases prevent the starting of the engine unless the unique, user defined PIN code has been entered first. In some vehicles the system can prevent Gear Change, Stall the Engine on Start and Lock the Gearbox (Vehicle dependent).
Undetectable Using Diagnostics
A modern thief can use diagnostics to detect circuit cuts on modern vehicles. The Ghost has no circuit cuts so it cannot be found using these methods.
No Radio Frequency Signals
Thieves cannot use sophisticated RF scanning, code grabbing technology to detect what security device your vehicle has when it does not transmit any signals like conventional security systems.
CAN Data Network
The use of the CAN data bus has several advantages including low risk during installation, low probability of detection, and allows for placement almost anywhere in the vehicle.
Because the unit communicates with the ECU on the databus to immobilise the vehicle there is no way a thief could listen for the tell-tale clicking of the traditional immobiliser relay.
Stops Key Cloning and ECU Swapping
A thief cannot simply add a new key or replace an ECU to bypass the Ghost and start the vehicle. Only a correct PIN code will allow the engine to start.
Tested For Each Vehicle
Due to the nature of the data bus communication the Ghost has been adapted and tested for every vehicle we list as compatible. If we list your vehicle you can be sure we have thoroughly tested its operation with the Ghost.
Emergency PIN Code Override
If the PIN code is forgotten, the car is sold or a button is broken there is a secure, unique reset code for each device.
Service/ Valet Mode
You can simply set your Autowatch Ghost in service mode which means if your are having your vehicle serviced or washed you can simply set it so they do not need to enter the code. However this is mode is restricted which means when the Autowatch Ghost is in service mode the vehicle cannot be driven over 36mph. If the vehicle is driven over 36mph the next time the engine is turned off and back on Autowatch Ghost will prevent the vehicle from starting unless you enter the pin.+