top of page



The immobilisers' job on a vehicle is to stop a thief from starting and driving away your car without the correct transponder chip found buried inside key for your car. Despite it having been compulsory for immobilisers to be fitted to all new cars since 1998, the technology has not majorly advanced in the form of transponders. Therefore, with the correct equipment, thieves can "boost" the signal of your keyless key and replicate/clone it, thus making away with your pride and joy.

The solutions? We offer various aftermarket immobliser kits that range from a pin pad to intelligent canbus integrated products, meaning your classic, luxury or supercar are permanently safe!

Car Thieves
Car immobilisers


Vehicle Start Blocking
The system will in most cases prevent the starting of the engine unless the unique, user defined PIN code has been entered first. In some vehicles the system can prevent Gear Change, Stall the Engine on Start and Lock the Gearbox (Vehicle dependent).

Undetectable Using Diagnostics
A modern thief can use diagnostics to detect circuit cuts on modern vehicles. The Ghost has no circuit cuts so it cannot be found using these methods.

No Radio Frequency Signals
Thieves cannot use sophisticated RF scanning, code grabbing technology to detect what security device your vehicle has when it does not transmit any signals like conventional security systems.

Silent Operation
Because the unit communicates with the ECU on the databus to immobilise the vehicle there is no way a thief could listen for the tell-tale clicking of the traditional immobiliser relay.

Stops Key Cloning and ECU Swapping
A thief cannot simply add a new key or replace an ECU to bypass the immobiliser and start the vehicle. Only a correct PIN code will allow the engine to start.

Emergency PIN Code Override
If the PIN code is forgotten, the car is sold or a button is broken there is a secure, unique reset code for each device.

Service/ Valet Mode
You can simply set your immobiliser in service mode which means if your are having your vehicle serviced or washed you can simply set it so they do not need to enter the code. However this is mode is restricted which means when the immobiliser is in service mode the vehicle cannot be driven over 15mph. If the vehicle is driven over 15mph the next time the engine is turned off and back on the immobiliser will prevent the vehicle from starting unless you enter the pin.

bottom of page